Galvanized 4- Hole Open 60 Degree Angle

$5.93

Part#: APGFS-5145-60EG Categories Features for Struts, Hardware, Architectural and Ornamental

DESCRIPTION

A galvanized 4-hole open 60-degree angle is a metal bracket used in construction and carpentry. It is made of galvanized steel, which means it has been coated with a layer of zinc to protect it from corrosion. The 4-hole open designation indicates that it has four holes for screws or bolts, and the 60-degree angle describes the angle at which the bracket is bent. These brackets are used for joining or reinforcing wood or metal components at a 60-degree angle, providing stability and support in various structural applications.

Hole Diameter-9/16″

Hole Spacing End Distance 13/16″

Hole Spacing Center to Center- 1-7/8″

Thickness- 1/4″

Width 1-5/8″

Angle 3-1/2 x 3-11/16

* Prices subject to change without notice due to the Metals Market fluctuations.
* All ‘value length’ and ‘value pack’ item measurements are subject to a “mill tolerance”. A product may be produced several thousandths of an inch, either over or under the stated thickness, and still be within “mill tolerance”. This does NOT apply to Cut To Size items. Those will be +.125″, -0.00″ tolerances.

Physical Address:

1240 Majesty Dr., Dallas, TX-75247

Mailing Address:

P.O. Box 560626, Dallas, TX-75247

Direct Any Correspondence To:

METALS 4U

1240 Majesty Dr., Dallas, TX-75247

+1 (214) 231-1434

Buy Securely — UPS Ships Direct to You!

Need Some Help?

WARNING

CALIFORNIA PROPOSITION 65

This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov

Prices subject to change without notice due to the Metals Market fluctuations. | All ‘value length’ and ‘value pack’ item measurements are subject to a “mill tolerance”. | A product may be produced several thousandths of an inch, either over or under the stated thickness, and still be within “mill tolerance”. This does NOT apply to Cut To Size items. Those will be +.125”, -0.00” tolerances.